Engine Build Sheet Template - The heads have been ported but the crank is stock to my knowledge. It also came with a dyno sheet. I built the custom 4 link (8.8) in the 1988 rx7 as well as some of the engine build in the '88 and the transmissions in both. A close examination of shaver's engine reveals the details. What does it take to make 700 hp from a 10.5:1 compression, pump gas, 427? He said that it wouldn't be a problem. I had the engine build sheet but lost it. When i tore into the engine, i could still see the cross hatching on the cylinders so i took it to the machine shop to be cleaned up and installed new bearings, rings and gaskets. Rods, and brand, any length as long as pistons avalible for size. Picked up from craigslist for 1350.00 after some negotiation. I had all the bits and looked at everything else. Thick ss material and a ss screw on cap with o'ring. I kept some parts for use on the new car and the spreadsheet came with it. Engine is rebuilt, unknown milage but very few (under 10,000) from the information i gathered. Must be off the shelf no custom built.
Rods, And Brand, Any Length As Long As Pistons Avalible For Size.
What does it take to make 700 hp from a 10.5:1 compression, pump gas, 427? I kept some parts for use on the new car and the spreadsheet came with it. Anyway, i want to swap a pontiac 400 in it someday and want to know a good budget build to get around 400lb/ft of torque. 302 built and ran in a early bronco.
It Also Came With A Dyno Sheet.
I do however have a link to the engine running before it was removed and sold to me. A close examination of shaver's engine reveals the details. Engine is rebuilt, unknown milage but very few (under 10,000) from the information i gathered. The build had less than 1000 miles on it from what i can tell before the previous owner wrapped the rear end around a pole.
I Have Each Area Of The Car Broken Up Into Sections, Hyperlink Where I Can And The Number Of Every Scanned Receipt.
Picked up from craigslist for 1350.00 after some negotiation. I had the engine build sheet but lost it. I contacted him and asked him if he would build me a overflow to my dimensions and the way i wanted it built. When i tore into the engine, i could still see the cross hatching on the cylinders so i took it to the machine shop to be cleaned up and installed new bearings, rings and gaskets.
Overbore Max.060 Crank, Any Brand, Off The Shelf.
The mh build worksheet started out with my previous car which i parted out. Must be off the shelf no custom built. The heads have been ported but the crank is stock to my knowledge. Thick ss material and a ss screw on cap with o'ring.